JL Audio C1-650 – 6-1/2″ 2 Way Component Speaker System

Description

JL Audio C1-650 – 6-1/2″ 2 Way Component Speaker System

C1 loudspeakers offer excellent audio performance in a form factor designed for easy mounting behind factory grilles.

Description

The C1 woofers benefit from JL Audio’s proprietary FEA modeling and expertise. This knowledge is used to create speakers that can play loud, while maintaining smooth, dynamic, low-distortion sound.

At the heart of the C1-650 is an exclusive 6.50-inch (165mm) stamped-steel frame and DMA-optimized motor system. A mineral-filled, injection-molded polypropylene cone is suspended with a rubber surround at the front and a carefully designed flat Conex® spider at the top of the voice coil, to precisely control voice coil movement.

Braid wires are carefully routed and attached to the spiders to prevent fatigue and buzzing. These are the same kinds of features and materials normally found on much more expensive speakers.

Equipped with a true edge-driven aluminum dome tweeter, the C1 speakers further distinguish themselves from others in their class with superior high-frequency clarity and definition.

The tweeter design inherently has excellent off-axis response and high frequency extension. It also benefits from the damping of a silk surround suspension and ferrofluid in the voice coil air gap, as well as the superior strength of a neodymium magnetic circuit.

Features

• Continuous Power Handling (RMS) 50W
• Recommended amplifier power (RMS) 10 – 75 W / Ch.
• System efficiency 91.0 dB at 1 W / 1 m
• Nominal system impedance 4 Ω
• System frequency response 48 Hz – 24 KHz ± 3 dB

Subwoofer dimensions (picture # 1)

• Frame outer diameter* (A) 6.25 in / 159 mm
• Grate Tray Outer Diameter (B) 6.84 in / 174 mm
• Motor Outer Diameter (C) 3.15 in / 80 mm
• Coaxial Tweeter Front Projection (D) N/A
• Front grille protrusion** (E) N/A Mounting
• Hole Diameter (F) 5.02 in / 128 mm
• Mounting Depth (G) 2.07 in / 53 mm
  *Does not include mounting tabs **Protrusion of front grille measured from mounting surface

Tweeter dimensions (picture # 2)

• Flush mount diameter (A1) 1.87 in / 48 mm
• Surface mount diameter (A2) 1.69 in / 43 mm
• Recessed mounting hole diameter (B) 1.625 in / 41 mm
• Flush mounting depth (C) 0.76 in / 19 mm
• Flush mount tweeter Front projection (D1) 0.29 in / 7 mm
• Front projection of surface mount tweeter (D2) 0.92 in / 23 mm